miniland baby baby pur Manual De Instrucciones página 16

2. TO CHANGE AND INSERT BATTERY ON THE REMOTE CONTROL
Step 1: Slide the plastic lock to the left.
Step 2: Lift the plastic cover upwards to open.
Step 3: Remove old battery.
Step 4: Insert new battery.
Step 5: Slot the hooks in, then press the plastic cover down.
Step 6: Slide the plastic lock to the right to lock the cover.
1. ASSEMBLY INSTRUCTIONS
(1). Opening the front cover
Place both hands on the buckles on each side of the cover and
pull outwards, then lift upwards to open the casing.
(2). Take out filters in sequence
Take out the pre-filter and Activated Carbon Filter together, then
loosen the tighten band, separate the pre-filter and Activated
Carbon filters, and finally take out the HEPA filter.
(3). Installing the filters
Repeat the process in reverse order, install the HEPA filter first,
followed by the Activated Carbon Filter and finally the pre-filter.
(Before installation, tighten the pre-filter and Activated Carbon
Filter together first.)
(4). To reattach the front cover
Hold the cover with both hands on either side, make sure the
buckles and botches are aligned from the top, and then snap on
both buckles to fasten the cover.
16