Initial Installation - TechniSat DiGYBOXX T4 Instrucciones De Funcionamiento

5 Initial installation

After you have read through the safety instructions and connected the device according to
the instructions contained in section 4, it is now time to switch on the device (as described
in section 7). When you start the device for the first time, the start screen of the Auto
Install installation wizard appears. The installation wizard helps you to make the most
important settings on the digital receiver.
You can cancel the initial installation at any time by pressing the red function button.
Use the green function button to return to the previous installation step should you need
to correct any erroneous entries.
If the initial installation is incomplete or cancelled, your device will start with the standard
presets.
The initial installation process shown here is only an example. The exact initial installa-
tion process depends on which settings you make. Therefore, follow the on-screen instruc-
tions precisely.
Menu language
> When you start the installation wizard, the first selection screen you see is for the
Menu language.
Use the up/down arrow buttons to highlight the desired operating language.
>
Confirm by pressing OK.
>
Confirm by pressing OK, to accept the selection.
>
Country adjustment
Use the up/down arrow buttons to select the time zone that corresponds to your
>
country.
The time is automatically set according to your selection.
Confirm by pressing OK, to accept the selection and proceed to the antenna
>
configuration.
13