Thermal Cut-Out Reset; Cleaning, Care & Maintenance; Troubleshooting - Buffalo L310 Manual De Instrucciones

UK
L371/S007/S077 - Use a suitable container to remove the water from the appliance.

Thermal Cut-Out Reset

This appliance is fitted with a Thermal Cut-Out safety feature. Should the temperature exceed safe levels
the appliance will automatically cut power.
The Safety Cut-out switch is located on the underside of the appliance, between the back feet. To reset the
appliance after a sufficient cool-down period:
Press the small reset switch down until it clicks, using a blunt pointed instrument.
1.
The appliance is now reset and can be used as normal.
2.
WARNING: Ensure the appliance has cooled down and is empty before resetting the
switch, as it may need to be tipped slightly to gain access to the switch.
Cleaning, Care & Maintenance
Note: Always switch off and disconnect the appliance from the power supply before
cleaning. Always allow the appliance to cool before emptying or cleaning.
• Wipe down the exterior of the appliance with a damp cloth.
• Some cleaning agents may cause damage when used for a prolonged period on stainless steel. Use a
suitable stainless steel cleaner.
• Dry the exterior thoroughly.
• Wash all removable parts in warm, soapy water.

Troubleshooting

If your BUFFALO appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault
The unit is not working
3
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The Thermal Cut-Out switch
has activated
The thermostat has not been
set correctly
The heating element has failed Call BUFFALO agent or qualified
Action
Check the unit is plugged in correctly
and switched on
Call BUFFALO agent or qualified
technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified
technician
Reset Thermal Cut-Out switch
Set the thermostat to a higher
temperature
technician