DeWalt DW450S2 Manual De Instrucciones página 7

• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask
if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA/Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Specifi cations
MODEL
HEIGHT
WIDTH
LENGTH
WEIGHT
OPERATING PRESSURE
AIR CONSUMPTION PER 100
CYCLES *
LOADING CAPACITY
CROWN WIDTH
FASTENER DIAMETERS
FASTENER LENGTH
*Take the actual rate at which the tool will be run to determine the
amount of air required. For instance, if your fastener usage averages
50 fasteners per minute, you need 50% of the cfm listed above which
is required to operate the tool at 100 fasteners per minute.
5
DW450S2
8.84" (225 mm)
2.50" (64 mm)
13.98" (355mm)
4.60 lb. 2.08 (kg)
2
70 – 120 psig (4.9 – 8.43 kg/cm
2.1 cfm (59.5 lt/min) @
80 psi (5.62 kg/cm 2 )
Up to 160 fasteners
1" (25.4)
16 Gauge
1/2"–2" (13–80 mm)
)