Troubleshooting - HEISSNER F650P Instrucciones De Uso

Fit plastic tubes M in the desired length to the handle of the suction hose Q with the suction nozzle O
�
and connect the suction hose L to the connector H of the tank I.
Attach the drain hose C to the tank connector I.
�
Insert the mains plug into a suitable plug socket. The supply voltage should correspond to the informa-
�
tion on the type plate (230V/50Hz). After inserting the mains plug, the integrated drainage pump runs
briefly and stops after a few seconds.
Operation (Switch position "I"): Device switches on audibly. Suction can begin. The filling time for the
tank depends on the respective usage conditions and can vary. When a factory-set level is reached, the
drainage pump automatically starts up and empties liquid from the tank. Suction can continue during
this without any interruptions.
The suction head and container with the drainage pump are connected with a waterproof plug-in
�
connector. If it is necessary to disconnect this for maintenance reasons, never place the suction
head on a damp surface and always prevent moisture from entering the plug-in connector.

TROUBLESHOOTING

Possible fault
Cleaner has no suction Open airflow gate in handle Q
Suction performance
weak, no suction
Water coming out of
the motor head
Smoke from the motor
head
Container does not
empty
Device runs but has no
suction
GUARANTEE
These guarantee terms describe additional guarantee services. Statutory warranty claims are not affected by
this guarantee. The guarantee starts with the date of purchase by the ultimate user; this must be evidenced
by the presentation of the guarantee card and/or proof of purchase (receipt, invoice). The guarantee cov-
ers only faults caused by material flaws or manufacturing errors. The guarantee service is provided – at
our discretion – by the repair free-of-charge of the returned product or the supply or a new, fault-free
appliance. If the HEISSNER GMBH product range no longer includes an identical product, the guarantee
can be fulfilled by supplying a product with comparable technical features. Claims under guarantee will
F650P Betriebsanleitung-Garantie.indd 13
Cause
Hose connectors or handle on suction
hose L loose
Motor head not closed
Filter sponge R not fitted via float
cage in the motor head or has fallen
out
Filter sponge R not fitted via float
cage in the motor head or has fallen
out, causing suction of dust into the
motor area.
Drain hose C bent
Drain hose C is too high
Drainage pump P blocked
Drainage pump P faulty
Suction nozzle O blocked
Suction hose L blocked
Height difference too great
Float basket jammed
Solution
Close airflow gate in handle Q
Screw connector or handle flush into
suction hose L
Place motor head in position flush,
close closing clips.
Fit filter sponge R via float cage. If
necessary, dry filter sponge first fol-
lowing prolonged operation.
Fit filter sponge R via float cage.
Remove bend
Lower drain hose C to max. 2 m
above the device
Remove blockage
Check pump P and replace if neces-
sary
Clean suction nozzle O
Clean suction hose L
Hold suction pipe M flatter on the
surface of the pond
Switch off and make the float basket
move smoothly
1 EN
13
28.09.2017 10:19