Installation And Replacement Of Batteries - hafele 959.23.050 Manual Del Usuario

2. Remove the 3M stickers from the holding plate and fit the plate over the end of the lens, then
screw the locking barrel onto the threaded sleeve of the camera and tighten. This will hold the
plate in position on the door. Make sure that the arrow on the plate is pointing upwards. (FIG.2)
3. The data cable must be properly plugged into the back of the screen; excess cable should be
carefully positioned in the groove in the back of the screen.
4. Hook the screen onto the bracket at the top of the plate and secure with one small screw
through the hole at the bottom of the screen housing. (FIG.3)

Installation and replacement of batteries:

Installation:
1. Slide the cover upwards and open outwards as shown in the diagram.
2. Insert the batteries in accordance with the "+" "-" sign on the cover.
3. Proceed in the reverse order to close the cover.
Attention:
1. DO NOT use force when opening and closing the cover to avoid damaging the cover.
2. DO NOT push the open cover in the opposite direction to avoid any damage to the cover.
When the low battery indicator is on, please replace the batteries to avoid any damage to the
hook the
screen case
fix the screw
11/44