Beretta Exclusive Green E C.S.I. Serie Manual Del Instalador página 15

12 - START-UP AND OPERATION (EXCLUSIVE GREEN E C.S.I.)
The boiler produces heating and domestic hot water. The control panel contains the main boiler control and management functions.
Description of commands
Heating water circuit
temperature selector
ON-OFF-RESET
function selector
Operating mode button
Heating water temperature selector: sets the heating water
temperature.
DHW temperature selector: sets the domestic hot water temperature.
Setting parameters selector: using in calibration and programmation
phase.
Function key:
- ON the boiler is electrically powered and waiting for operating
requests ( -
- OFF the boiler is electrically powered but will not respond to operating
requests
- RESET resets the boiler following a fault
Operating mode button:
operating mode: pressing it, the indicator "function selector"
to: (winter) or (summer)
Info button: shows a sequence of information concerning the operating
status of the machine.
Filling button: pushing it, the boiler automatically fills the system until
the pressure reaches 1 to 1.5 bar.
Switching on
b
The first time you turn the boiler on and in case of maintenance
work, before using the appliance you must fill the siphon with
water and make sure that the condensation is evacuated correctly.
Fill the condensation collection siphon pouring 1 litre of water into
the boiler combustion-analysis outlet with the boiler off, and check
that:
- the safety cut-off device is floating
- water is flowing correctly from the discharge pipe out of the
boiler
- the condensate outlet connection line is watertight.
If the condensate outlet circuit (siphon and pipes) is working correctly,
the condensation level will not exceed the maximum.
Filling the siphon before using the appliance, and the use of a safety
cut-off device inside the siphon, prevent exhaust gases from being
released into the environment.
Repeat during standard and non-standard maintenance work.
INFO Filling
button button
DHW
temperature
selector
Setting parameters
)
button allows to choose the desired
Description of display symbols
graduated heating water temperature scale with heating function
symbol
graduated domestic hot water temperature scale with domestic hot
water function symbol
fault symbol
reset symbol
pressure value
external sensor connection
selector
heating/domestic hot water temperature
or
fault symbol (e.g. 10 - no flame)
function selector (turned to the chosen operating mode:
or summer
burner operating symbol
anti-freeze function active symbol
system filling function symbol
moves
fill symbol
ENGLISH
winter
MAX
15