Beretta Exclusive Green E C.S.I. Serie Manual Del Instalador página 18

EXCLUSIVE GREEN E C.S.I. - R.S.I.
Note
During filling, the boiler does not perform other functions. For example, if
there is a request for domestic hot water, the boiler is unable to provide
it until filling has finished.
Note
If circuit pressure reaches 0.6 bar, the pressure value flashes on the
display (Fig. 14); if it falls below a minimum safety value (0.3 bar), fault
code 41 appears on the display (Fig. 15) for a certain time, following
which, if the fault persists, fault code 40 is displayed (see chapter on
"Troubleshooting").
In the event of fault 40, press
circuit.
After fault 40 has been resolved, the boiler will carry out an automatic
vent cycle lasting for about 2 minutes: the wording "SF" will appear on
the display (Fig. 16) and the "function selection indicators"
up in sequence.
Press button to stop the automatic vent cycle.
If you have to fill the system several times, contact the Technical Service
Centre to check whether the heating circuit is watertight (see if there
are any leaks).
Information
Press , the display turns off and just the word InFO appears (Fig. 17).
Press the button to view operating information. Press the button again
to move on to the next piece of information. If the button is not pressed,
the system automatically exits the function.
Info 0 - shows the word InFO (Fig. 17)
Info 1 - only with the external probe connected, displays external tem-
perature (e.g. 12°C) (Fig. 18). The values shown on the display range
between - 30°C and 35°C. Beyond these values the display shows "- -"
Info 2 - shows circuit pressure (Fig. 19)
Info 3 - shows the set heating temperature (Fig. 20)
Info 4 - shows the domestic water temperature setted (Fig. 21)
Info 5 - displays the set heating temperature, in reference to the second
circuit, only if it is connected.
18
to reset and then to start filling the
14
15
will light
16
17
18
19
20
21