Interface Overview; Chiropro 3 Rd Gen Modes; Rotating Knob Functions Overview - Bien-Air Dental CHIROPRO 3rd Gen Instrucciones De Uso

6 Interface overview

6.1 Chiropro 3
rd
The Chiropro 3 Gen allows to visualize and control operation
parameters by the means of the LCD display.
A unique screen allows to use the following modes:
FIG. 1
• Operation mode (to perform an operation in 3 steps)
See chapter "7 Operation" on page 14 for details.
FIG. 2
• Settings mode (to set up operation parameters)
See chapter "8 Settings" on page 16 for details.
FIG. 3
• Special modes (to test system and reset settings)
See chapter "9 Special modes" on page 18 for details.
FIG. 4
A. Long press on the rotating knob (1) to switch between
Operation and Settings modes.
Note 1
See chapter "6.2 Rotating knob functions overview" on page 12 for
details.
See chapter "9 Special modes" on page 18 for entering special
modes.
12
FIG. 1
rd
Gen modes

6.2 Rotating knob functions overview

Note 2
Knob action Description
Increase current value, go to the element
CW rotation
on the right
Decrease current value, go to the element
CCW rotation
on the left
One short press Go to the next programmed step,
(Operation mode) acknowledge error messages
Enter selected setting, validate and store
One short press
the current setting value, exit the current
(Settings mode)
setting, acknowledge error messages
Switch between Operation and Settings
One long press
modes
Double short Enter special modes (only when gear
press ratio is selected in settings mode)
FIG. 2