Tool Identification; Technical Data; Main Components - FAR RAC 172 Instrucciones De Uso

RAC 172

TOOL IDENTIFICATION

The riveting tool RAC 172 is identified from a marking that
shows company name and address of manufacturer, designation
of the tool, CE. Always refer to the information on the riveting
tool when requesting technical service.

MAIN COMPONENTS

A) ................................................................................. Nozzle
B) .............................................................Head carring nozzle
C) ............................................................Balancer connection
D) ............................................................................ Nails tank
E) ........................................................................Oil tank plug
F) ............................................................... Protection bottom
G) ................................................ Compressed air connection
H) ....................................................... Tensile strenght button
I) .......................................................... Suction opening lever
A
B
Ø24
I
H
340
G
Company name
and address
Designation of
the tool
RAC 172
Serial number
C
E D
F
Ø145
75036036 - RAC172 – rev 02 - ( 04-2019 )
GB

TECHNICAL DATA

• Working pressure ......................................................6 BAR
• Min. int. diam. of the compressed
air feeding hose ................................... min. diam = 8 mm
• Air consumption per cycle .......................................10,9 Nl
• Maximum force .........................................6 BAR - 22725 N
• Stroke ................................................................... 19,5 mm
• Weight .................................................................. 2,800 Kg
• Working temperature .............................................-5°/+50°
• Root mean square in total acceleration
frequency (Ac)
to which the arms are subjected ............................ 2,5 m/s
•
A-weighted emission sound pressure level
•
Peak C-weighted instantaneous sound pressure
•
A-weighted sound power
AIR FEED
The air feed must be free from foreign bodies and humidity
in order to protect the tool from premature wear and tear of
the components in movement, therefore we suggest to use a
lubrificator group for compressed air.
HOW TO USE YOUR RIVETING TOOL (fig. f1-f2-f3)
WARNING!
Before using the tool, it is compulsory to fit the
nails tank (D) and the nails baffle (L).
Press lightly for assembling the nails baffle (L), as shown in
the figure f3.
After the clamping, the sheared nail is piped by the riveting
tool and ejected from the back. By swinging the lever (I) you
can activate the suction. By the suction nail system, the rivet
remains in the nozzle also turning over the head of the riveting
tool downwards: this detail increases a lot the usefulness of
the riveting tool.
Do not keep the rivet with your fi ngers!
If you use the nails tank (D), when it is full of nails do not use
the riveting tool. Disconnect the tool, unscrew the nails tank (D)
and empty it properly. DO NOT DISPERSE ANY NAIL! Screw
the nails tank (D) and start again to work.
f1
Ø60
I
................. 74 dBA
...... <130 dBC
........................................... 87 dBA
2
11