Coltene SPEC 3 Manual Del Usuario página 19

Owner's Guide
Recommended separation distances between portable and mobile RF communications equipment and the S.P.E.C. 3
The S.P.E.C. 3 ® LED Curing Light is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the S.P.E.C. 3
the portable and mobile RF communications equipment (transmitters) and the S.P.E.C. 3
maximum output power of the communications equipment.
Rated maximum output power of
transmitter in watts (W)
0.01
0.1
1.0
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated using
the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according
to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects
and people.
11.4 EN/IEC 60601-1-2:2007 Sub-clause 5.2.2.2 Table 6
LED Curing Light can help prevent electromagnetic interference by maintaining a minimum distance between
®
Separation distance according to frequency of transmitter in meters (m)
150kHz to 80MHz
d = 1.2√ P
.12
.38
1.2
3.8
12
EN
® LED Curing Light as recommended below, according to the
80MHz to 800MHz
d = 1.2√ P
P
.12
.38
1.2
3.8
12
® LED Curing Light.
800MHz to 2.5GHz
d = 2.3√ P
.23
.73
2.3
7.3
23
19