Curtain And Soft Furnishing Care; Fluff Brush; Ironing Function; After Using The Steam Brush - Lervia KH 1270 Instrucciones De Uso

Curtain and soft furnishing care

• Creases and wrinkles can be removed from
draperies by hanging them over a pole.
• Then simply follow the directions given under
"Clothing care".
• Always carry out a test first at a concealed part.
• If you are using the appliance horizontally, every
now and then hold it upright so as to have the
maximum steam performance.

Fluff brush

• Threads, fluff and hairs can be easily removed
with the red fluff brush e by slowly brushing
over the garment with it from left to right.
• You can clean the fluff brush e by brushing with
it in the opposite direction (from right to left)
over, for example, a remnant of material.

Ironing function

• Dismantle the brush attachment w from the
appliance (see "Attaching/detaching the brush
attachment").
• Connect the appliance to a correctly installed
and earthed mains power socket.
• Adjust the temperature regulator 3 as per the
international point symbols (Care Label) or the
type of material. The heating-up control lamp 5
glows. As soon as the set temperature has been re-
ached, the heating-up control lamp 5 goes out .
Washing label Type of material Temperature
Chemical fibres,
e.g. viscose,
polyester
Silk, Wool
Cotton, Linen
If doubt exists, start with a low temperature and
gradually increase it to a higher one. With sensitive
materials we recommend carrying out an ironing
test at a concealed part (inside seam).
• Should the heating-up control lamp 5 glow during
• You can repeatedly press the steam blast button
Should you press the steam blast button 8 whilst
the heating-up control lamp 5 is glowing the result
will be condensed water instead of steam, and water
will drip from the sole of the iron 0.
Should the water tank 1 become empty while the
appliance is in use, remove the plug 7 from the
power socket before refilling it.
• If you want to put the appliance down during
regulator 3
•
(low

After using the steam brush

temperature)
• Place the temperature regulator 3 at the position
••
(medium
• After use, ALWAYS remove the plug 7 from the
temperature)
•••
• Pour away any water remaining in the water
(high
temperature)
- 22 -
Note:
the process, release the steam blast button 8
and wait for a few moments until the heating-up
control lamp 5 extinguishes.
8 until the heating-up control lamp 5 glows or
water drips from the sole of the iron 0. Then,
wait until the heating-up control lamp 5 extin-
guishes before activating a further blast of
steam.
Note:
use, fold out the stands 9 to the front and place
the appliance on them. When you are ready to reu-
se the appliance, simply fold the stands 9 back
to the rear.
"MIN".
power socket.
tank 1 to do this, open, the water fill opening
2 of the water tank 1, turn the appliance upsi-
de down and lightly swivel it.