Operation As Part Of A Home Automation Network; Disconnecting The Appliance From The Power Supply - S&P EMIDRY-D Manual De Instalación. Instrucciones De Uso

Once 5 seconds have elapsed with no further buttons pressed, the
programmed setting is accepted, the display once again shows the ambient
temperature, the blob flashes and the timer commences its countdown.
3 Once the programmed duration has expired the appliance performs one of
the following two operations:
- If the appliance is in STOP it switches to
- If the appliance is in
8.7 Locking and unlocking the controls
To avoid undesired changes or manipulation by
unauthorised persons, the control can be locked or
unlocked when desired. To do this, press the
and keys at the same time and maintain them
pressed for two seconds.
The display will show (LL), indicating that the
keypad is locked. After four seconds have passed
without touching any key, this selection is validated
and the device returns to normal screen. Unlock
following the same procedure.

9. OPERATION AS PART OF A HOME AUTOMATION NETWORK

EMIDRY-D heaters with a home automation terminal are factory-ready for
automatically receiving commands from a home automation controller. For
home automation commands to be correctly executed, the appliance must be
in mode. If the appliance is in
except , which it will treat as
all commands as belonging to
normal. When the appliance is in STOP mode it shall ignore all home
automation commands.
When the appliance is manually set to STOP mode, it ignores all home
automation commands. In the absence of home automation commands the
appliance shall behave as manually programmed.

10. DISCONNECTING THE APPLIANCE FROM THE POWER SUPPLY

ATTENTION:
It must be taken into account that with the circuit breaker switch on and/or
the plug connected, the device is live (operational).
or it switches off and remains in STOP.
,
mode it will obey commands for all modes
. If the appliance is in
mode, except STOP, which it shall execute as
19
.
mode it shall interpret