Rear Squeegee Blade Replacement - Clarke FOCUS Serie Manual De Instrucciones

Figure 33
Figure 34
Figure 35
Figure 36
Page -56-
Maintenance

Rear Squeegee Blade Replacement

If the rear squeegee blade is worn and does not dry
the floor well, follow this procedure:
1. Remove the squeegee assembly from the
machine.
2. Remove the squeegee blade and inspect it.
3. Rotate the squeegee blade to obtain a new
cleaning edge. Replace if necessary.
4. Reinstall the squeegee blade.
5. Reinstall the squeegee assembly on the
machine.
6. Readjust the settings on the squeegee as
required (see "How to Adjust Squeegee").
Squeegee Maintenance
The squeegee blade may be rotated for longer life.
Keep sharp corner on floor for best cleaning
results. See figure 33. To rotate follow this
procedure:
1. Remove Clamp.
2. Remove blade and rotate to new edge.
3. Replace squeegee.
4. Replace clamp.
Cleaning the Vacuum Hoses
Make sure the squeegee is over a suitable drain.
1. Use a garden hose to flush through the
recovery hoses.
2. Side Squeegee - Position garden hose to the
squeegee side of the hose and flush
thoroughly.
3. Recovery Hose - Position garden hose
inside recovery tank. NOTE: Do not place
hose in vacuum intake (see figure 34),
damage will occur.
Re-center Front Wheel
If the front wheel gets out of adjustment and the
machine does not drive straight when the joystick
is pointed forward, follow this procedure:
1. Remove 4 screws holding foot plate to solution
tank (see figure 35).
2. Locate two black wires tied together and
marked "reset sw" (see figure 36).
®
Clarke
Operator's Manual -Focus Rider Scrubber
EN