Instruction Sheet; Safety Precautions - König Electronic KN-STUDIO20 Manual De Uso

Photo studio

INSTRUCTION SHEET

Technical specifications:
Lighting colour temperature:
Ra:
Voltage:
Lamps:
Wattage of lamps:
Reference exposure value:
Width of object to be shot:
Size of open position:
Size of closed position:
Photo 1
Method of Operation:
1. Open the four reflecting boards, and then open the background board from under the reflecting board.
See Photo 1.
2. Attach the background to the background board and bottom reflecting board using the small clamp.
3. Close the top reflecting board onto the background board using the small clamp. See Photo 2.
4. Put the object to be shot onto the background, switch on the 230 V power, turn on the lamps for 3 to
5 minutes, then you can start taking the pictures.
5. Set the white balance of DC to "A" or "
background, please use the ISO200 f/8 1/60 exposure value for test shooting, to choose other colour
backgrounds, please increase the exposure value.
6. While shooting, if the effect of a top light to dim the project is needed, please raise the top reflecting board
slightly upwards; If the effect of left light to dim the project is needed, please open the left reflecting board
slightly. If the effect of right light to dim the project is needed, please open the right reflecting board
slightly.
7. When shooting is finished, please turn off the power. To store, please remove the background, close the
background board, then close the bottom and top reflecting boards, and finally close the left and right
reflecting boards.
8. To change lamps, please turn off the power, remove the transparent protective cover by loosening the
bolts, pull out the broken lamp and insert a new lamp, then put the protective cover back.

Safety precautions:

ENGLISH
5400 K
>90
230 V
Two pieces
2 x 24 W = 48 W
ISO200 f/8 1/60 (white background)
Approx. 30 cm
Approx. 47 x 47 x 47 cm
Approx. 47 x 47 x 9 cm
Photo 2
" or "K" or "PRE ". To take photos with white colour
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
2