Usage Instructions - PNI Turbo Heat Manual De Usuario

COMPONENTS:
ELECTRIC DRAWING:

USAGE INSTRUCTIONS:

Usage:
1. Please check before use the electric wire. Please do not use the socket lower than 10A.
2. Place the convector on a flat surface to avoid being toppled.
3. Set the convector's power: "I" - 800W, "II" - 1200W or "I"+"II" - 2000W (800W+1200W)
4. There is a thermostat knob for adjusting heating. You can rotate the knob to get your desired heating level.
5. For the convector with turbo, there is a independent switch for this function
6. If you stop using the convector, turn off all the power switch, then unplug it
7. If you want to move the convector from one place to another, use the side handles. Unplug the convector before
moving it.
8. Usage of the timer:
- The heater will be always on when the slide switch is in TIMER position "I"
- The heater will be always off when the slide switch is in TIMER position "0"
- The timer operates when the slide switch is in TIMER position "
To set the timer, rotate the clock dial clockwise, until the current time is aligned with the indicator arrow at the centre
" "
When you wish the heater to switch ON, push the corresponding time segment outwards from the centre. Each segment
represents around 15 minutes. For example, if you want the heater continuously ON for 2 hours, push 8 segments
outwards the centre.
".
3
EN