Key Automation 900CT-824S Manual De Instrucciones página 19

FUNCTIONS \ VALUES
ELECTRONIC CLUTCH
(sensitivity)
MOTOR SPEED
AUTOMATIC CLOSURE
(seconds)
OPEN COMMAND
CONDOMINIUM
(OPENING ONLY)
ELECTRIC LOCK
BATTERING RAM
SP/LC OUTPUT
% SLOW MOTION
SLOW MOTION SPEED
LIMIT SWITCH
No. OF MOTORS
PRE-FLASH
CLOSE AFTER TRANSIT
TIMER / MAGNETIC LOOP
(to be connected on P/P)
SOFT START
SOFT STOP
PHOTOCELL F2
OPERATION
MOTOR TYPES
COUNTER
N.B.: each function variation is confirmed upon completion of closure
Average
-- Maximum
maximum
-- Minimum Maximum
pedes-
NO YES
trian only
Open Activating the P/P function prevents the automation from stop-
Stop Open Close
Close
Activating the condominium function, the first P/P impulse opens
NO YES
YES
(when
NO (only when
opening /
opening)
closing)
Selection parameter for output as an open gate indicator or courtesy light
Parameter G=0 enables the gate open indicator where the
flasher frequency indicates the automation status :
•
Indicator Courtesy
•
on light
•
•
Parameter G=1 enables the courtesy light timed for 90 sec. from
the first opening or closing impulse
NO 10%
Medium
-- low
NO YES Motors with electric limit switch selection parameter (SN50-24)
-- 1
NO 1 sec 2 sec.
Activating the Close after Transit function, with automatic closure
NO YES activated, permits the closure of the automation in the shortest
When you activate the function Timer / Magnetic Coil via parameter P after
terminating total opening if step/step contact is kept closed the automatic
NO YES
contact is opened again, if there are several step/step impulses during the
NO YES movement of the automation, the control unit will command the
NO YES movement of the automation, the control unit will command the
active
active when
only Selection parameter for F2 operation when opening or when
opening and
when
closing
opening
PS300-
PS-200 SN-20
24/400-24
=10000 manoeuvres) it is possible to set a maximum number of ma-
NO 4=40000 noeuvres that as they decrease will signal the request for service with
regular luminous flasher signals upon automation closure. To reset the
count hold down the S2 enter and S1 up/dwn buttons together for 5 sec.
19
Average mini-
minimum mum
Motor speed selection parameter
Automatic closure selection parameter
ping; remember that this enabled function may be critical for
automations with great inertia
and only accepts reopening while the door is closing
YES Selecting the Battering ram parameter, the control
unit will permit the releasing and coupling of the
electric lock, commanding the closing motors for a
brief period of time
slow while opening
quick while closing
on steady when the gate has stopped open
it turns off with the gate closed
20% 30% 40%
Medium
High
low high
2 1 or 2 motor automation selection parameter
3 sec. 8 sec.
period of time without waiting for the automatic reclosure
closing time is locked so that the gate never closes until the step/step
standby time for automatic closing the time will be continuously reset
Activating the Soft Start function, during the first seconds of
motor to operate at a reduced speed for a softer start
Activating the Soft Stop function, during the last seconds of
motor to operate at a reduced speed for a softer arrival
opening+closing
SN50-24 INT-24
Activating the function, selecting a value between 1 and 9 (1 value
Sensitivity selection parameter:
Maximum sensitivity= minimum
force
% of travel in slow motion
selection parameter
Speed during slow motion
selection parameter
Activating the Pre-flash func-
tion, the flasher is activated
for the selected period of time
before each closing movement
Motorisation type selection
parameter