Refitting The Filter; Cleaning And Storing The Cleaner - Zodiac Pool Care VORTEX 1 Instrucciones De Montaje Y Del Uso

2-Notice Vortex1 ANG 1210_Mise en page 1 07/12/10 15:40 Page17
•
Place the cleaner on its wheels.
•
Push the button on the cover and lift the cover
•
Remove the filter basket holder from the cleaner
•
Separate the filter basket from its holder
•
Rinse the filter basket, its holder and the cleaner.

4.2. REFITTING THE FILTER

•
Place the filter hooks on the small receiving pins in the rear of the cover
•
Position the filter and lock it using the front clip
to the cover it should not fall when being held using the cover handle.
•
Fit the hinges over the edges at the rear of the cleaner body
•
Close the cover and lock it using the front clip. Gently lift the cleaner using the handle in order
to make sure the cover is correctly fitted.

4.3. CLEANING AND STORING THE CLEANER

The cleaner should be cleaned regularly using slightly soapy water. Do not use solvents such as
trichloroethylene or equivalent.
Rinse the cleaner generously using clean water.
Do not let your cleaner dry in the sun by the pool.
REMINDER: The cleaner cable must be disconnected from the control box before removing
the cleaner from the pool.
(Figure 7-1).
(Figure 7-2).
(Figure 7-3).
2
(Figure 8-2). If the filter is correctly fixed
(Figure 8-3).
2
17
Figure 7
(Figure 8-1).
Figure 8
3
3