MS 50604 Manual De Instrucciones página 16

adding water into or moving the humidifier.
16. Don't turn on the humidifier when there is no water in the water
basin.
17. Pay attention to the environment of the humidifier to ensure the
normal operation of the humidifier and avoid unnecessary accidents.
VII. Solução de problemas.
In case your humidifier does not work properly, please examine your
machine before asking for maintenance service.
Fault symptom
Power light off
No blow and no mist.
Power light on, air
blow but no mist.
Peculiar smell of
water mist.
Power light on, no
blow and no mist.
Small output.
Abnormal noises.
Mist spilled from
around the nozzle.
The water in the water
tank does not flow down.
Analysis of causes
Power is disconnected.
Main switch off.
No water in water tank.
Cover of water level pro-
tection switch not closed
properly.
New machine.
Dirty water or water stored
for too long time.
Water level too high in the
water basin.
Incrustation formation of
the transducer.
Dirty water or water
stored for too long time.
Resonance caused by insuffi-
cient water in water tank.
Resonate with surface
where the unit is placed.
Gaps between nozzle and
water tank.
The hold of water tank
cover is blocked.
Failure recovery method
Connect the power supply and turn it on.
Turn on the switch.
Add water into the water
tank.
Reinstall the cover.
Keep the water tank uncovered
in a cool place for 12 hours.
Clean the water tank and
replace the water.
Take out some water from the
basin and screw up the cover.
Clean the transducer.
Replace with clean water.
Add water into the water
tank.
Place the unit on steady
surface or on the ground.
Soak the nozzle in water
before use.
Clean the blocked hole.