MTD OEM-190-180A Manual Del Usuario página 11

Figure 4-6
NOTE: If you decided to leave the hitch support only
finger tight during the assembly process, tighten all of the
hardware securely at this time.
If Mounting Assembly onto 700 Series Tractors
NOTE: Install two clevis pins through the mounting
assembly and secure to the 700 series mounting brackets
installed earlier with click pins provided with the model
700 mounting kit. Refer back to Figure 4-1 and see Figure
4-7 below.
Align hole on bracket
with hole on tractor
Figure 4-7
NOTE: If you decided to leave the hitch support only
finger tight during the assembly process, tighten all of the
hardware securely at this time.
1. Install the vertical support bracket onto the mounting
assembly of the tractor by hooking it over the hitch plate as
seen in Figure 4-8.
2.
Align hole on bracket
with hole on tractor
3.
4.
Align the vertical support bracket with the mounting hole
that best suits the deck size of your machine. See Figure
4-8.
NOTE: Hole "A" is suggested for 38" decks, while Hole "B"
is suggested for 42" decks, and Hole "C" suggested for
46" decks. Some kits may contain plates with deck size
suggestions instead of letters.
Figure 4-8
Secure the vertical support bracket to the mounting
assembly using a carriage bolt (710-0276) and wing knob
(720-04122) from hardware pack 689-00328A. See Figure
4-9.
Figure 4-9
Install the hanger assembly onto the upright support
bracket using a carriage bolt (710-0276) and wing knob
(720-04122) from hardware pack 689-00328A. See Figure
4-10.
S 4 — A
ection
& i
SSembly nStAllAtion
11