ROBLIN Ombre 800 Manual De Instrucciones página 8

Fitting the Hood canopy
• Adjust the two screws Vr, in the brackets 11a, so that
they are at the start of their travel (B).
• Hook the hood body to the two brackets 11a.
• Connect the Hood to the Mains Power Supply,
inserting a bipolar switch with a contact aperture of at
least 3mm.
• Open the top panel. (See the paragraph on USE)
• Open the Bottom Door by pulling it downwards with
your hands.
• Remove the Metal Grease Filters using the handles
provided.
• From the inside of the hood body, turn screws Vr to
level the hood body itself.
Warning: should the rear wall not be completely flat and
cause the two glass panels not to be aligned, pls turn on
the two knobs in the lower part inside the hood body until
you reach the perfect alignment of the two glass panels.
• Fasten the safety screw 11.
• Replace the Metal Grease Filters, then shut the top
panel. (See the paragraph on USE)
• Disconnect the hood from the mains power supply.
Warning: Should the door encounter an obstacle while
opening or closing it will block. When the obstacle is re-
moved and the button is pressed again the door will open.
Warning: In the event of a malfunction, check the fuse.
Replacing the fuser
• The fuser is placed up on the left side. Turn the fuser
holder as indicated. Replace the fuser with one hav-
ing the same features.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ø 150
or 120mm, the choice of which is left to the installer.
To install a ø 150 pipe
• To install the dumper 10
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
To install a ø 120 pipe
• To install a ø 120 mm air exhaust connection, insert
the reducer flange 9 on the dumper 10.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove any activated charcoal filters.
EN
Connections
ø 150
10
10
11a
Vr
(B)
11
ø 120
9
8 8