GB
fastening. Before use, always make sure the accessory is completely fastened on both sides. When
the seat is lifted upwards, it must not detach.
Lift lever "A" on the adapter on both sides to remove the seat from the chassis (fig.15).
REVERSIBLE SEAT (fig.15, fig.16, fig.17)
Lift lever "A" on both sides and remove the seat.
Position the seat facing forward or facing the parent.
Put the seat back on the stroller chassis, see "fitting the seat" for proper assembly.
FITTING THE BUMPER BAR (fig.18, fig.19, fig.20)
Assembly: align the bumper bar and insert it in place on both sides, you will hear a click when it
is locked correctly.
Disassembly: press button "A" on both ends of the bumper bar and pull it outwards at the same
time, to remove it.
To open it on one side only: press button A on one side of the bumper bar and pull to open it like
a gate.
FITTING THE CANOPY (fig.21, fig.22)
Assembly: Insert the plastic clips inside the respective guides located on both sides of the stroller.
You will hear a click when they are locked correctly in place. Secure on the side with the ZIP .
Disassembly: Open the ZIP on the side, press button "A" and lift to remove the canopy.
FITTING THE FOOTMUFF (fig. 23)
Secure the ZIP on the side, attach the velcro as shown in the figure.
USE
ADJUSTING THE SEAT (fig.24)
The seat can be adjusted in different positions.
Lift adjustment lever "A" located on the back of the backrest and recline the seat to the desired
position. Release the lever and make sure it locks properly.
SAFETY HARNESS (fig.25)
Put the brakes on before sitting your child in the stroller.
Releasing the buckle: Press button "A" and pull out the parts.
Place your child in the stroller and adjust the harness to fit him/her.
Fastening the buckle: Insert part "a" in part "b", a click will indicate proper fastening.
Always fasten the restraint system properly.
ADJUSTING THE FOOTREST (fig.26)
Press buttons "A" and adjust the footrest to the desired position.
17
BIKINI Plus