Using The Dispensers; Important - Whirlpool 7MWFC9822HC1 Manual De Uso Y Cuidado

Using the Dispensers

1. For automatic dispensing, open the bulk dispenser drawer
using the handle at the base of the washer/dryer. For a single
load, open the single load dispenser drawer at the top left
corner of the washer/dryer and disable the Load & Go option.
2. Add laundry products as described below.
3. Slowly close the dispenser drawer. Make sure it is completely
closed.
Adding HE detergent to dispenser
Load & Go bulk dispenser
Use only High Efficiency (HE)
liquid detergents. The bulk
dispensers will hold about 67.6 oz
(2 L) or 33.8 oz (1 L) of liquid HE
detergent, depending on dispenser,
or enough for many loads of laundry.
To Fill Bulk Dispeners:
Open the dispenser drawer by pulling on the handle at the
base of the washer/dryer. If desired, the bulk dispensers
can be completely removed from the drawer.
Locate the Load & Go bulk
dispenser. Gently pull up on the
tab located on the bulk dispenser
lid to lift the fill door.
Fill to the "MAX" line (see
illustrations at right) with HE
liquid detergent or liquid fabric
softener (1 L dispenser only).
Close fill door. It will click into place.
Make sure the concentration setting
is correct (see the "Choosing the
Right Detergent" section).
It is recommended that you rinse
out the Load & Go containers when
refilling, when changing detergent
types or concentrations, or when
the washer/dryer will not be used for
an extended period. For instructions
on cleaning the dispenser cartridge,
see the "Washer/Dryer Care" section.
For instructions on changing
detergent concentration,
see Step 12 in the "Using
the All-In-One Washer/Dryer"
section.
NOTES:
■ A small amount of water may remain in the single load
■ See "About Detergent Concentration" for information on
■ When detergent in the dispenser is running low, the display
■ Add single-dose and Oxi-type boosters to the drum before loading
Adding detergent for a single load
Use only High
Efficiency (HE)
detergent.
Use only High Efficiency
(HE) detergent.
Pour a measured amount of HE detergent into detergent
compartment. For powdered detergent, lift the selector
to the high position. For liquid detergent, push down the
selector to the low position.
Do not overfill; adding too much detergent may cause
Tab
detergent to be dispensed into the washer/dryer too early.
"MAX" line
Powdered detergent:
Lift the selector to the high
position. Add directly to the
compartment.

IMPORTANT:

■ Disable Load & Go dispenser(s) as desired (see Step
■ Do not add single-dose laundry packet to dispenser
dispenser from the previous wash cycle. This is normal.
detergent concentration.
will show the detergent level (Low).
items. See the "Using the All-In-One Washer/Dryer" section.
Selector
12 in the "Using the All-In-One Washer/Dryer" section)
before starting a single load.
drawer.
HE detergent
compartment
Liquid detergent:
Push down the selector
to the low position. Add
directly to the compartment.
9