Panasonic Lumix H-PS14042 Instrucciones De Operación página 6

∫ Detaching the Lens
≥ To protect the lens, turn off the power of the digital
camera and confirm that the lens barrel is
recessed.
While pressing on the
lens release button D,
rotate the lens toward
the arrow until it stops
and then remove.
• Attach the lens rear cap so
that the lens contact point
does not get scratched.
• Attach the body cap to the camera so no dirt or
dust will get inside the main unit.
∫ Attaching and
Detaching the Lens Cap
Pinch the lens cap as
shown in the figure to
attach or detach.
• Be careful not to lose the
lens cap.
6
VQT3S52
∫ Attaching Filters
≥ Attach or detach the filter when the lens barrel is
recessed.
≥ Vignetting may occur if using 2 or more
MC protectors (optional: DMW-LMCH37),
PL filters (optional: DMW-LPL37) or ND filters
(optional: DMW-LND37), or if using thick
protectors and/or filters.
≥ The filter may become impossible to remove if
excessively tightened, so please refrain from

tightening it too strongly.
≥ It is possible to attach the lens cap with the filter
already attached.
≥ You cannot attach a conversion lens or adaptor to
this lens.
(As of September 2011)
used, but attaching any other element may cause
damage to the lens.
A filter may be