Desoutter cvi3 Manual De Usuario página 5

Mounting on aluminium profile
● Position the 2 mounting plates on the I/O
expander as shown below by using the 2
screws supplied in the kit.
● Mount the I/O expander on the aluminium
profile.
WIRING
● Remove the front and the right side panels by
unscrewing the screws.
● Wire and connect all connectors.
● Pass the cables through the corresponding
grommets.
● Insert grommets Ø 0 when free space in
order to ensure tightness.
● Fit the cable entry sytem to the I/O expander
by using the 4 screws M5x15 supplied in the
kit.
The label marked 1 corresponds to the
upper row of connectors.
11/2014
LABELING
● Customize the labels of the front panel.
Disassembly
● Loosen the 4 screws on the left side of the
I/O expander as shown below.
● Remove the labels.
1
2
● Write a description on the location marked by
1 and 2.
Reassembly
Ensure that the seal is correctly
mounted.
● Add some glue and tighten the screws as
shown below.
1.5 N.m
5 / 40
6159931360
Issue no: 05
Series: -
Loctite 243