Introduction - Elinchrom Quadra Hybrid S/A Head 20139 Manual De Instrucciones

User Manual

INTRODUCTION

QUADRA HYBRID HEAD A / S
Dear Photographer,
Thank you for buying the Quadra Hybrid A-Head or S-Head for the Ranger Quadra Battery Power Pack. All Elinchrom
EN
products are manufactured using the most advanced technology. Carefully selected components are used to ensure
the highest quality and the equipment is submitted to many controls both during and after manufacture. We trust
that it will give you many years of reliable service. All flash units are manufactured for the studio and location use
of professional photographers. Please read the instructions carefully, before use, for your safety and to obtain the
maximum benefit from the many features. This unit embodies the very latest technology and is manufactured in
Switzerland, by ELINCHROM LTD., complying with all Swiss and E.C. relevant norms.
FCC CLASS B COMPLIANCE STATEMENT / USA & CANADA
This equipment has been tested and complies with the norms for a class B digital device, pursuant to Part 15 of the
FCC Rules and meets all requirements of the Canadian Interference-Causing Equipment Regulations. These norms
are to provide adequate protection against interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does not
cause harmful interferences to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to correct the interferences by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ELINCHROM LTD. is not responsible for any radio or television interference caused by unauthorised modifications
of this equipment or the substitution or attachment of connecting cables and equipment other than those specified
by ELINCHROM LTD. The correction of interference caused by such unauthorised modification, substitution or
attachment will be the responsibility of the user.
2