Areas Of Use; Actions Before Starting - Stiga TITAN 540 D Instrucciones De Uso

• Set the throttle control to idle. Do not stop the
engine.
• Clean away any leaves, grass or any other ob-
jects from the outside of the oil cooler. See 5.12.
• Leave the engine idling until the temperature
has dropped, the indicator has gone out. The
machine can then be used as normal.
• If the temperature has not dropped within 5
minutes, stop the engine and take the machine
to an authorised workshop for repair.
3.5.6 Engine temperature indicator (1:I6)
Too high engine temperature is indicated partly by
the indicator and partly by a buzzer that sounds.
The engine must never be loaded or
operated at more than idle speed with
the temperature indicator illuminated
or when the buzzer sounds. Risk of
serious engine damage.
The engine temperature indicator and
buzzer are only activated when the igni-
tion is in the operating position.
The engine temperature indicator and buzzer give
a warning when the engine temperature exceeds a
harmful level.
When the engine is running the indicator should
not be illuminated and the buzzer should not
sound. If the indicator illuminates or if the buzzer
sounds during operation, carry out the following:
• Set the throttle control to idle. Do not stop the
engine.
• Clean away any leaves, grass or any other ob-
jects from the outside of the radiator. See 5.12.
• Leave the engine idling until the temperature
has dropped, the indicator has gone out and the
buzzer stopped. The machine can then be used
as normal.
• If the temperature has not dropped within 5
minutes, stop the engine and take the machine
to an authorised workshop for repair.
In the event of an indication of too high engine
temperature, check the coolant level. See 5.4.
3.5.7 Oil pressure indicator (1:I7)
The engine must never be run when the
oil pressure indicator is illuminated.
Risk of serious engine damage.
The oil pressure indicator is only acti-
vated when the ignition is in the oper-
ating position.
The oil pressure indicator gives a warning when
the engine oil pressure falls below a harmful level.
When the engine is not running the indicator
should illuminate as there is no oil pressure.
ENGLISH
When the engine is running the indicator should
not be illuminated. If the indicator illuminates dur-
ing operation, stop the engine immediately and
take the machine to an authorised workshop for re-
pair.
3.5.8 Hour meter engine (1:I8)
Indicates the number of working hours. Only
works when the engine is running.
3.5.9 Air filter indicator (5,6:I9)
The indicator warns of a blocked air filter. If the in-
dicator is red, the air filter must be replaced. Then
reset the indicator by pressing its button.
3.5.10 Hydraulic oil level indicator (8:I10)
The oil level must be visible through the transpar-
ent glass when the machine is level.
If the oil level is too high there is a risk of oil flow-
ing out through the bleed valve. If the oil level is
too low there is a risk of an increase in the oil tem-
perature and damage to the hydraulic system.
The machine may only be used together with orig-
inal accessories.
Optional kits are available for the machine that
contain the equipment required in order to drive on
public roads. The contents of the kits are adapted
according to local regulations. Contact an autho-
rised dealer for purchase information and pur-
chase.
5 STARTING AND OPERATION
The machine may not be operated
unless the engine casing is closed and
locked. Risk of burns and crushing
injuries.
Ensure no one is near the pivot point of
the machine when the engine is
running. There is a risk of serious
crushing injury between the machine's
rear and front sections.
Depending on the implement used,
counter weights might have to be
mounted on the machine. The axle
pressure of a wheel axle may never
exceed 900 kg or 70% of the total
weight of the machine

5.1 ACTIONS BEFORE STARTING

Carry out the following before starting the ma-
chine:
• Check/top up with fuel.
• Check the engine oil level.
Original instructions for use

4 AREAS OF USE

EN
85