General Operation - AEG BSS 4820 Instrucciones De Servicio

12 DC IN 5 V/2 A – micro-B USB charging port
13 DC OUT 5 V/1 A – charging port USB type A for charging
of smartphones
14 USB port type A for music playback
Scope of delivery
1x Bluetooth sound system
1x Charging cable (type A USB to mini-B USB)
1x AC adapter
1x Operating instructions
First Use of the Device/Introduction
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Power supply (11)
• Insert the grid plug into a properly installed socket. Con-
nect the device with the plug connector by inserting its
plug into the DC IN 5 V/2 A jack of the device.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
CAUTION:
• The included AC adapter may only be used with this
device. Do not use it for other devices.
• Use only an AC adapter with 5 V (
AC adapter may damage the unit.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Charging the built-in Battery
You can also operate the device with the built-in battery.
Charge the battery as follows:
1. Insert the Mini USB plug from the charger cable into
the socket (12) of the unit. Connect the USB plug to a
powered-on computer. The indicator lamp lights up red
and the battery charges.
2. If the battery is completely charged, the indicator light (3)
will light up green.
3. Remove the charger cable from the speaker and PC.
CAUTION:
Never leave the unit unattended when it is charging.
NOTE:
• The battery is only charged while the PC is switched on.
• Do not connect the player for a long period of time to
a laptop computer disconnected from mains power
Otherwise the laptop computer' s battery may be
discharged.
NOTE:
• The charging time varies according to battery use.
• Should you not use the device for longer than half a
year, charge the battery at least every 6 to 12 months.
The battery will also constantly discharge when
switched off.
• You can use the included AC adapter to charge the
battery. Connect the AC adapter to a correctly installed
outlet and to the power supply connection (11).

General Operation

Turning the device on/ off (9)
• Switch on the unit with the button (9). The unit starts
with the last selected source.
• Press the button again to switch the unit off.
NOTE:
After about 15 minutes without signal, the device will auto-
matically switch to standby.
Volume
By pressing the VOL /VOL buttons (4) you can adjust the
desired volume.
Sound Settings
If necessary, change the EQ setting in your playback unit to
). A different
create the best sound.
Indicator lamp (2)
The indicator lamp changes its color according to the operat-
ing mode.
Color of the indicator lamp
Alternate flashing red and blue In Bluetooth pairing mode
Lit blue
Flashes blue
Lit green
Flashes green
Lit red
USB charging port (13)
You can charge your smartphone via this port. Use the USB
cable of your smartphone for the connection.
NOTE:
• Because of the many different smartphone types being
offered today and their different charging capacities,
the charging time depends on the smartphone being
used and it operating mode.
• Playback of audio files via this port is not possible.
• Your smartphone is being charged even during battery
operation. However, please note that this discharges
the built-in battery of the unit.
English
31
Operating mode
Bluetooth connection exists
Music playback via Blue-
tooth
In USB mode
USB playback stopped
In AUX IN mode