Important Safety Precautions - Martin Yale intimus POWER 15.90 S Instrucciones De Uso

GB
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
<< The machine may not be operated by more than
one person at any given time!
The machine was designed for safe operation by "one
person only".
<< During the shredding process no other work
may be performed on the machine (for example
cleaning, etc.)!
<< The machine is not a toy, and is not suitable for
use by children!
The overall technical safety concept of this machine
(dimensions, feed openings, emergency shutdown
devices etc.) does not provide for any guarantee
regarding hazard-free operation by children.
APPLICATION:
The 15.90 S / 16.50 S shredder is used in all
areas where large quantities of printed material
need to be shredded.
The machine can shred cardboard and crumpled
paper as easily as it shreds smooth paper.
3
4
5
2
1
Fig. 5

IMPORTANT SAFETY PRECAUTIONS

INITIAL START UP
The shredder should only be fed with
paper or cardboard!
Shredding other data carriers can cause
injury(e.g. by splintering of hard materials)
or may damage the shredder (e.g. des-
truction of the cutting system).
POWER SUPPLY CONNECTION:
a) The maximum value for loop impedance at the
mains connection point is 0.5 Ohms.
b) The conductor cross-section of the power
supply line should be of a magnitude so as
to cause a 15% voltage drop in the case of a
6
machine blockage (inhibit current = 6 x nominal
current).
7
8
9
10
11
12
13
<< Danger of injury!
clothing, ties, jewelery, long hair or other
loose objects away from opening!
<< Danger of
ning!
<< In case of danger switch the machine off with the
mains switch, or with the emergency switch, or
unplug the machine!
<< Always unplug the machine from the mains power
supply before opening the machine!
Repairs may only be performed by trained per-
sonnel!
CHECKING THE RUNNING DIRECTION:
1. Free the emergency-stop rail (pull out the rail)
2. Unlock the locking switch (2) and press the
3. Check that the shredder is running in the correct
Now that everything has been correctly assembled
and connected, you can proceed to operating
the machine.
10
15.90 S/16.50 S
Keep all loose articles of
injury! Never insert fingers into ope-
(14) (fig. 6) on the shredder feed table. Switch
on the main switch (1) (fig. 5); i.e. to position
„1".
„cutting system forward" button(3) (fig. 5).
direction and correct the phase relation of the
power plug if necessary.
Correcting the phase relation of the
power plug may only be carried out
by a qualified electrician!
14
Fig. 6