Assembling The Battery - Stihl AR 900 Manual De Instrucciones

English
If the battery is subjected to unusually
high loads for which it was not designed
(e.g. heavy impact or a fall), always
check that it is in good condition before
continuing work – see also "Before
Starting Work". Do not continue
operating the battery if it is damaged. In
case of doubt, contact your STIHL
servicing dealer.
After finishing work
Clean the battery – see "Cleaning the
Battery".
Further Safety Precautions
see www.stihl.com/safety - data - sheets
28

Assembling the Battery

Connecting the Adapter
Remove the cover (1) – press the
N
tabs (arrows) inwards and push the
cover upwards.
3
2
Insert the plug (2) in the socket (3) –
N
line up lugs on plug with slots in the
socket.
4
5
Push the plug into the socket as far
N
as stop, then turn it clockwise until
the plug's latch (4) engages audibly.
Fit cable (5) in the cable duct (6) in
N
the housing – see also "Positioning
the Cable".
Push the cover (1) into place,
N
making sure the cable is properly
seated in the duct and not pinched.
Positioning the Cable
The cable can be fitted in different cable
ducts.
If the power tool being used with this
battery is:
6
AR 900