Sima COBRA MKNO Manual De Instrucciones Original página 40

8. FREQUENTLY OCCURING ISSUES
PROBLEM
Motor won ´t start
Blade slows or stops while cutting
Blade is wearing too quickly
Belts are wearing too quickly
POSSIBLE CAUSE
Low oil level alarm is activated
Fuel feed is closed
Motor switch in ´off ´position
Insufficient acceleration
Loosen belts
Moves forward too fast
Incorrect blade being used
Motor not powerful enough
Insufficient cooling
Machine moves too fast
Inapropriate blade
Belts slip on the pulleys
Badly aligned belts
16
SOLUTION
Add oil until the correct level is
reached
Open the valve
Turn ´on´
Put accelerator on higher setting
Tighten belts
Reduce accelerator
Use correct blade.
Have the motor serviced
Make sure the water is
correctly
Reduce throttle
Use correct blade, specific to the
material you are cutting
Tighten belts
Lower throttle
Use appropriate blade for the surface
you are cutting.
Align the belts
ENGLISH
flowing