Publicidad
Idiomas disponibles
Idiomas disponibles
17 – Multiplexing instruction for Urano back to back
Before starting to multiplex two cabinets Urano back to back, remove the protective film on the plates.
Turn the feet in order to obtain a perfect alignment of the units. Then proceed as per following instruction (FIG: 13 page 5)
1. Fix top spacers on the back of one case. Holes are already predisposed.
2. Bring near the other case and ensure that they are perfectly aligned. Do not screw the top spacers to the other case.
3. Remove the dowels as pe
4
. Assemble the top carter and screw only side spacers (3 pieces each side) to both cases. Holes are already drilled.
5. Install side carters.
6. Install cover using a drop of silicon (only in case of external
18 – Electrical diagrams
The electrical diagram of the electronic control is enclosed to this manual. The electrical diagrams are on page 6
Legend:
CE =
Electronic device
TR =
Transformer 230V / 12V
M1 =
Compressor
ST =
Temperature probe
R2 =
Anti-mist heater
R3 =
Dripping heating
EV =
Solenoid
IL =
Lights
F =
Phase
19 - Conformity Declaration
A copy of the declaration of product conformity can be requested by filling in the form availa
http://www.oscartielle.it
18
r FIG. 13 page 5, only in case of external lights or any other accessory
/conformity
lights or any other accessory)
and 7.
ble a the internet address:
Publicidad
