Segurity Recomendations - Sima VENUS-85 Manual De Instrucciones Original

6. SEGURITY RECOMENDATIONS.

The machines with electric motor should always be
connected to a standard electrical box that has a circuit
breaker and a Residual-current device in accordance with
the characteristics of the engine ( see table).
WARNING: Always use earth plug before starting-up the
machine.
•
Use normalised cables
•
Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the
machine.
•
Make sure that the extension cords are not in contact with points of high temperature, oil, water, sharp
edges.
•
Do not use high pressure water to clean circuits or electrical elements.
•
The damaged electrical cables should be urgently replaced.
•
Mantengan en su posición los elementos y protecciones de seguridad.
•
Always use approved protective items (gloves, helmet, goggles, boots ... ..)
•
Turn the machine on the network and do not handle or operate on the mechanical and electrical machine with
the engine running.
•
Cutting table machines should be used by people who are familiar with its operation.
•
It´s not allow to access and manipulation of the machine to people who are not familiar with the machine
before.
•
Work clothes should not include loose clothing that could get caught in moving parts of the machine.
•
Before starting the machine, read the instructions carefully and observe compliance with safety standards.
Learn well how to stop the machine quickly and safely.
•
Place the machine on a flat and well lit
position.
•
Make sure the machine is in perfect technical condition and fully operational.
•
Do not operate the machine if all the protections and safeguards are assembled which have been designed
for that purpose.
•
When moving the machine, always verify that engine and moving parts are blocked.
•
Use only diamond blades specified in this manual.
This machine MUST NOT BE USED IN THE RAIN. Cover with waterproof
materials. If the machine has been exposed in the rain check before
connecting the electrical parts are not wet. Always work with good
lighting conditions.
WARNING: You must follow all safety recommendations outlined in this
manual and comply with regulations for the prevention of occupational hazards of each place
SIMA, S.A. is not responsible for the consequences possibly generated but the inadequate use of the
materials cutting machine SPADA model.
and you do not switch the machine on until it´s got a balance