Connections; Connecting To A Video System - Singing Machine SMI-1222 Manual De Instrucciones

CONNECTIONS

CONNECTING POWER
Power the system from a standard AC outlet by using the built in power cord.
CAUTION: The built in AC power cord has a polarized plug that fits into the wall outlet only one way. If the plug does
not fit properly, turn it over and try again. Do not force it.
CONNECTING TO YOUR HEADPHONE
A headphone jack is provided for using headphones instead of the built-in speakers. (Headphones are sold
separately.) A warning that excessive sound pressure from earphones and headphones can cause hearing
loss; The MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.
BEFORE CONNECTIONS ARE MADE
!
Always turn off the Singing Machine, TV and other components prior to connecting or disconnecting any cables.
!
Please refer to the following is well as the instruction manuals of the other components if connection problems
come out or more information is needed.

CONNECTING TO A VIDEO SYSTEM

In order to watch a DVD, picture CD or sing-along with a CDG on TV screen, you must connect the included RCA
cables (Red-White-Yellow colored plug cable) to the output jack on the rear panel of the unit. Then connect the
other end of the RCA plug to the AUX and VIDEO Input jack of the video system such as TV. (If your television
does not have the required Video Input, you will need an RF Modulator (Radio Frequency Modulator), which
connects through your TV antenna or cable line and serves as Video Input. Please view the illustration below as a
reference guide.
REAR VIEW OF
SINGING MACHINE
HEAD- EXTERNAL AUDIO
PHONE SPEAKER OUTPUT
L
R
AUDIO OUT
L
(White Jack)
AUDIO OUT
R
(Red Jack)
NOTE : To only display the image on the video system, unplug the AUX OUT (L & R) cards. The audio will be
produced come out from the built-in speakers of the unit. If no sound is heard, check the volume settings of
the unit.
Please use the provided CDG disc to test the connections. The lyrics and music of songs on the disc will be
displayed on the TV screen.
COMMON WAYS TO CONFIGURE YOUR TV OR VCR
You must specify the source you wish to view when you are connecting the video out from the Singing Machine to
either a TV or a VCR. Every TV and VCR manufacturer accomplishes the set-up a little differently. Even though
every TV and VCR is a little different, the general idea is the same - if you have two sources of video signal (cable
or antenna and Singing Machine), you have to specify which one is displayed on the screen.
If you have never used the video input RCA jack or coaxial cable on your TV/VCR you should consult your
TV/VCR user guide. If you don't have your manual please contact your TV/VCR manufacturer for information
either by phone or by viewing their website for online assistance.
configure your TV or VCR to display the video connection.
The three most common ways to set up the TV/VCR are:
1) A 'Video' button may be on the TV/VCR or on the remote control. Pressing 'Video' may display the input from
your Singing Machine.
2) Try looking for a 'Video' channel between the regular channels on your TV/VCR. Do this by setting the channel
on the TV/VCR to channel 2 then pressing the 'Down' channel button to see if there is a 'Video In' or 'Line In'
between the lowest channel and the highest channel on your system.
3) The configuration may also be located in the set-up menu on the TV/VCR. Look for a section on 'Input
Selection' where you might be able to choose the input source i.e. 'Cable/Ant.', 'Video 1', 'Line In' or 'Video In'.
AUDIO
VIDEO OUTPUT
INPUT
L Cr/Pr Cb/Pb VIDEO
R
Y S-VIDEO
COAXIAL
VIDEO OUTPUT
(Yellow Jack)
VIDEO
IN
VIDEO INPUT
(Yellow Jack)
They will be able to tell you very quickly how to
E12
REAR VIEW OF
VIDEO SYSTEM
R L
AUX IN AUX IN
AUX IN AUX IN
R L
(Red Jack) (White Jack)