Irritrol LIFE DC Manual Del Usuario página 2

Irritrol Life DC Controller 1
INTRODUCTION
Remotely controlled system, LIFE DC is a Bluetooth® and waterproof irrigation controller with
no power supply. Control your irrigation through either the intuitive Irritrol LIFE DC App.
SPECIFICATION
POWER
- Power Supply: 9 VDC.
- Output: 9 VDC solenoid (latch type)
- Maximum 1 output ON at a time.
WORKING PRESSURE
- Qualified on DCL samples up to 6 bars of water pressure
WORKING TEMPERATURE
- From -10°C to 50°C
Step 1
WIRING
1. Connect the LIFE DC to the solenoids as described below. Use 9V pulse valves only.
+S- C P 1 2 3 4 5 6 C
2. You can connect on the P output a master valve. The output will automatically start 2s before
each station and during the watering of each stations. (not available on 1 station model).
+S- C P 1 2 3 4 5 6 C
3. (Option) If you want to install a rain sensor, cut the yellow wire of the LIFE DC and connect it
to the sensor.
The rain sensor when it is connected instead of the yellow wire affects all the 4 programs. If it
rains and the rain sensor is active, programs A or B or C or D will not start. It is necessary to
wait until the probe has dried to see the programs restart. The «All stations» command, in the
«Manual» menu of the LIFE DC App, does not take into account the condition of the rain sensor.
_ _ _
2 4 6
+S- C P 1 2 3 4 5 6 C