Base Installation With Lower Anchors; Safety Check; Uninstalling Base - UPPAbaby MESA Manual Del Usuario

BASE INSTALLATION WITH LOWER ANCHORS

STEP 3: Locate the lower anchor connectors on either side of the base and
remove by pushing the corresponding orange button on the top of the base
while pulling the connector out of the lower anchor storage pocket
STEP 4: Attach the lower anchor connectors to the vehicle lower anchors
located in the vehicle seat bight (crease of seat).
NOTE: Check lower anchor connectors are in the upright position.
STEP 5: Apply pressure firmly into the base allowing all the excess lower anchor
connector webbing to retract and tighten.
NOTE: Push into the seat bight (crease of seat). Installation is complete when
tightness indicator turns from red to green and stays green when downward
push is discontinued.
20 UPPAbaby MESA Instruction Book
3
5
• Base doesn't move more than 1 in side to
side at the belt path
• Ensure tightness indicator is green after
each use. If it is not, apply pressure by
pushing base into seat bight (crease of
seat) to tighten
• Lower anchor belts are secure and
4
untwisted
• Recline angle is correct. Base is level
when only green is visible between the
.
two arrows on the level indicator. No red
should be visible
STEP 1: Press the red button on the lower anchor connector
pulling the connector off the vehicle anchor
STEP 2: Store lower anchor connectors in designated housing found on
each side of the base.

SAFETY CHECK

.
.
.
LEVEL WHEN LEVEL WHEN
NO RED NO RED
VISIBLE VISIBLE

UNINSTALLING BASE

1
.
UPPAbaby MESA Instruction Book
LEVEL WHEN LEVEL WHEN
NO RED NO RED
VISIBLE VISIBLE
2
while
21