Seat Padding Installation - UPPAbaby MESA Manual Del Usuario

SEAT PADDING INSTALLATION

STEP 1: With the SIP in the lowest position, lay seat pad over carrier, open
Velcro ® flap and fit opening around SIP/headrest.
STEP 2: Tuck lowest side tab behind seat foam and under post. Repeat on
other side.
STEP 3: Place second side tab into designated plastic slot and third side tab
behind seat foam. Repeat on other side.
STEP 4: Tuck top 2 tabs into designated slots and pull headrest adjuster tab
through buttonhole
44 UPPAbaby MESA Instruction Book
1
3
2
4
STEP 5: Lift lower part of SIP and pull harness straps to each side of opening.
Secure padding panel with Velcro
STEP 6: Raise SIP/headrest into highest position.
STEP 7: Pull harness adjuster strap through opening in seat pad and install
pad around adjuster release button housing.
STEP 8: Wrap padding around front lip and install 4 lower plastic tabs.
STEP 9: Reconnect harness adjuster strap.
SEAT PADDING INSTALLATION
5
7
9
.
®
UPPAbaby MESA Instruction Book
6
8
45