Expanding Tool - Rehau RAUTOOL A-light Instrucciones De Uso

RAUTOOL A-LIGHT
PREPARING THE TOOL
Caution
Danger of injury!
Inexpert handling of the REHAU tool may result in personal
injury and/or property damage
- Make sure that the ball-headed pins are fully and safely snapped
in with each change of the jaw sets.
- Prior to changing the jaw sets, make sure to remove the battery
from the tool (unintentional actuation!).

Expanding tool

Expanding pliers:
When changing expander heads,
open expander completely (>90°
position).
Always screw expander heads
fully on. Use expander heads
according to pipe dimensions.
Turn the expander set until the
pin slips into the groove. Then fix
the jaws and expander set using
the ball-headed pins.
Caution: Insert ball-headed
pins completely.
Caution:
Insert expanding tool princi-
pally Into the pipe up to the
stop
24
- Before use, check the jaw sets, expander bits, expander sets and
the tool for damage or visible wear. Damaged tools must no longer
be used and must immediately be sent to an authorized REHAU
service center for repair.
- When inserting the expander bit, clip it always fully into the clam-
ping jaws. The full mounting groove surface of the bits must lie in
the clamping jaws. Before using the tool, the correct fit and the
clamping effect of the bits in the jaws must be checked (avoidan-
ce of dropping out!)
Expander set:
When using the expander set,
push the jaws (first long and
then short) first and then insert
the expander set into the cylin-
der.
Expander bit
When inserting the expander bit
for hydraulic expansion, clip the
expander bit of the respective
dimension into the corresponding
clamping jaws and check for fit
(clamping).