Operation
Drying clothes
Fig.
For drying clothes follow below
5
instructions:
1. Open the door, fill the drum with
your clothes and close the door.
Note:
The drum is illuminated if the door
is opened. This function eases
filling and emptying the drum.
2. Switch on the appliance with the on
/off button
3. Chose your program, referring to the
Program table.
4. Chose an additional function if
needed or set the time delay
(Startzeitverzögerung).
5. In the Mein Programm
you can define an individual program
with the desired special functions.
Turn the program selector to your
desired program, e.g. standard, Jeans
etc. and set the desired special
functions. Then press the Anti-
Crease
save the settings.
The program remains saved and can
be changed at any time as described
above.
6. The drying time can only
be set manually with the
ZEITVORWAHL key in the and in
the ZEITVORWAHL modes Warm,
Kalt, Auffrischen (adjustable
times can be found in the Program
table).
7. Push the start / pause button
The dryer starts the drying process
at the preset conditions.
IM_KTD9322A3_200603_V05_HR.indb 31
IM_KTD9322A3_200603_V05_HR.indb 31
.
program,
button for 3 seconds to
.
8. By pushing the start / pause
button
again the dryer stops
and the operation control LED is
continuously on. To continue the
drying process push the start /
pause button
When the drying program has finished
Fig.
6
an acoustical signal beeps 3 times and
0:00 is shown in the display. Open the
door and remove all clothes.
Caution
The door may only be opened if the
appliance is not running, e.g. after a drying
process is finished. Do not try to open the
door when the appliance is running to avoid
burns or scalding caused by hot steam or hot
surfaces. There is also a mechanical danger
due to the rotating drum.
Indicator lights
Extra dry
Child lock
Clean filters (warning)
Empty water container (warning)
Standard dry
Cycle phase status
Iron/damp dry
Time mode
Anti crease mode
Hygienic sterilization
Drum lamp on
English
again.
31
3/6/2020 5:07 PM
3/6/2020 5:07 PM