Koenic KTD 9322 A3 Manual De Instrucciones página 34

Size - A5
English
Cleaning the main filter
Warning
Before opening the service flap, place a
big cloth in front and below the flap. Large
amounts of water may leak when opening
the flap.
Reach into the opening of the service
Fig.
12
flap and open it. Pull the levers of the
main filter into the correct direction to
unlock and pull it out. Clean the filter
and rinse if necessary.
Warning
During reassembling make sure the sealing
of the filter fits correctly and make sure
the filter is locked properly in order to avoid
water leakage.
Cleaning the heat exchanger
If necessary, remove the fluff from the heat
exchanger approx. once every 2 months using
a vacuum cleaner and a brush nozzle. To do
so, open the service flap and remove the main
filter as described above.
Clean the heat exchanger without pressure,
otherwise it can be damaged.
Warning
Do not touch the heat exchanger with your
hands as this can cause injuries.
34
IM_KTD9322A3_200603_V05_HR.indb 34 IM_KTD9322A3_200603_V05_HR.indb 34
Cleaning air inlet
Fig.
The LED Filter
13
will indicate when the lint filter needs
to be cleaned.
Check the air inlet opening on the front
side on a regular basis and make sure it
is free from residues and not blocked.
Take of the service flap. Make sure the
air inlet grill and foam filter are clean.
Remove any residues and particles.
Install the service flap.
on the control panel
3/6/2020 5:07 PM 3/6/2020 5:07 PM