Intended Use; Additional Safety Rules - Panasonic EY7881 Manual De Instrucciones

Original instructions: English
EN
Translation of the original instructions:
Other languages
WARNING
Read all safety warnings and all
instructions. Failure to follow the warn-
ings and instructions may result in
electric shock, fire and/or serious
injury.
Save all warnings and instructions for
future reference.
I.

INTENDED USE

This tool is a Rotary Hammer for drilling in
concrete. In addition, the tool has a "rota-
tion only mode" without hammering. The
mode is suitable for metal-drilling,
wood-drilling.
II. ADDITIONAL
SAFETY RULES
Hammer safety warnings
- Wear ear protectors. Exposure to
noise can cause hearing loss.
- Use auxiliary handle (support handle)
supplied with the tool.
Loss of control can cause personal
injury.
- Hold power tool by insulated gripping
surfaces, when performing an opera-
tion where the cutting accessory may
contact hidden wiring or its own cord.
Cutting accessory contacting a "live"
wire may make exposed metal parts
of the power tool "live" and could give
the operator an electric shock.
1) While working, use safety equipment
such as protective glasses, and where
necessary an anti-dust mask, anti-slip
safety boots, helmet and ear protec-
tors.
2) If the bit becomes jammed, immedi-
ately turn the trigger switch off to
prevent an overload, which can
damage the battery pack or motor.
Use reverse motion to loosen jammed
bits.
3) Do NOT operate Forward/Reverse
lever when the trigger switch is on.
The battery will discharge rapidly and
damage to the main unit may occur.
4) During charging, the charger may
become slightly warm. This is normal.
Do NOT charge the battery for a long
period.
5) Do not strain the tool by holding the
speed control trigger halfway (speed
control mode) so that the motor stops.
6) To prevent injury during use, hold the
tool steady at all times and avoid
waving it around.
7) Make certain that there are no hidden
gas or water pipes, or electrical wires
in the area where you will be working.
Coming into contact with hidden pipes
or wires could result in electric shock,
or water or gas leaks.
8) Make sure to hold the object you are
working on steady.
9) Check for damaged parts.
• Check thoroughly for damage to the
protective cover and other parts
before operating.
• Check to make sure the tool and all
of its functions are working properly.
• Check the adjustment of all movable
parts, and check all fixed parts to
make sure they are fitted properly
and free of damage. Check all parts
of the tool for abnormal function.
10) When attempting to repair the protec-
tive cover or other parts, please follow
the instructions in the user manual. In
cases where there are no instructions
in the manual, please take it back to
the store to have it repaired.
11) If the tool gets exceptionally hot
during use, please take it in for
service and repair.
12) To avoid potential injury, keep face
and hands away from the drill bit and
any shavings.
13) Do not wear gloves when operating
the tool, as they may get caught by
the drill, leading to injury.
- 10 -