Velleman CAMZWBUL13 Manual Del Usuario página 4

Overview
5.
Coaxial power supply
Installation
6.
• Mount the camera in a suitable location using the included mounting bracket and screws.
Do not install behind a glass (or other) window as this will impact image quality. Note
that the camera has two mounting holes on either side, for wall or ceiling mounting.
When the image appears upside down, dismount the camera and remount it using the
other mounting hole.
• The camera comes with a sun shield that might be useful depending on the installation
location. First slide the adapter of the sun shield in place and secure it with the centre
screw. Then slide the camera in the adapter and secure it with the 4 screws (2 on either
side). Do not use excessive force on the screws. Check whether the sun shield is not
blocking the camera view.
• The other side of the RG58U cable must be connected to connector [F] of the coaxial
power supply.
• Connect a monitor (not incl.) to connector [G] (cable not incl.).
• Plug the mains connector [C] in the mains (230V/50Hz).
• Switch on the coaxial power supply with switch [A]. The status LED [B] turns green.
• Adjust the brightness of the camera image by setting the dip-switches [E] on the back of
the power supply. The two upper-switches increase the brightness (brighter), while the
two lower switches decrease the brightness (darker).
• In case of a blown fuse [D] in the power supply, replace it with a 250V/2A fuse.
00 (22/09/2008)
CAMZWBUL13
4
FRONT
A. on/off switch
B. power LED (green)
BACK
C. mains connector
D. fuse
E. brightness switches
F. camera connector
G. monitor connector