Chauvet Professional Epix Drive 900 Guía De Referencia Rápida página 4

ÉPIX Drive 900 QRG
Signal
Connections
Control
Personalities
Personality
Pixel
7-CH-Drive
8-CH-fixture
5-Section
10-Section
25-Section
50-Section
Art-Net™
Connection
sACN
Connection
Kling-Net
Connection
The ÉPIX Drive 900 can link to a controller or controller software using an Ethernet
connection. If using other Art-Net™, sACN, or Kling-Net compatible products with the
ÉPIX Drive 900, they can be controlled individually on a single network. See the User
Manual for information about how to connect and configure the product for these
signals.
The ÉPIX Drive 900 uses Art-Net™ and sACN for its control personalities:
Channels
3 per LED
(150 per ÉPIX Strip Tour)
(450 per ÉPIX Bar Tour)
7
8 per ÉPIX product
15 per ÉPIX product
30 per ÉPIX product
75 per ÉPIX product
150 per ÉPIX product
In the LED Section modes, all ÉPIX products scale to the same number of
channels. For example: in 10-Section mode, an ÉPIX Bar Tour will be controlled in
10 sections of 15 LEDs, while an ÉPIX Strip IP 50 will be controlled in 10 sections
of 5 LEDs.
Art-Net™ is an Ethernet protocol that uses TCP/IP that transfers large amount of
DMX512 data using an etherCON RJ45 connection over a large network. An
Art-Net™ protocol document is available from www.chauvetprofessional.com. Art-
Net™ Designed by and Copyright Artistic Licence Holdings Ltd.
This product is not designed to respond to controllers sending in Broadcast mode
via Art-Net™. For best results, use Unicast mode. For information about which
control protocol your controller uses, please contact the manufacturer of your
controller.
Also known as ANSI E1.31, Streaming-CAN is an Ethernet protocol that uses the
layering and formatting of Architecture for Control Networks to transport DMX512 data
over IP or any other CAN compatible network.
Kling-Net is a network protocol that allows auto configuration of display devices using
an etherCON RJ45 Ethernet connection. Refer to the ArKaos software manual for
detailed instructions on programming this product.
For smooth-running operation, ArKaos Kling-Net requires a gigabit
(1000 Mbps) Ethernet card and network router.
Description
Complete pixel control
Dimmer, auto programs, and strobe
Dimmer, auto programs, strobe, and dimmer speed
Controls LED output in 5 sections of LEDs
Controls LED output in 10 sections of LEDs
Controls LED output in 25 sections of LEDs
Controls LED output in 50 sections of LEDs
4
EN