Introduction - ESAB LAE 1250 Instrucciones De Uso

GB
1

INTRODUCTION

LAE is a constant voltage welding rectifier. It is designed SOLELY for submerged
arc and gas metal welding (MIG/MAG).
LAE is designed for use with PEG--1 control equipment.
The welding current range can be extended by connecting two welding rectifiers in
parallel. To ensure the correct division of current between welding rectifiers a
parallel operation device is required. (Order no. 321 181--880).
WARNING
This product is intended for industrial use. In a domestic environment this product
may cause radio interference. It is the users responsibility to take adequate pre-
cautions.
ARC WELDING AND CUTTING CAN BE INJURIOUS TO YOURSELF AND OTHERS. TAKE PRECAU-
TIONS WHEN WELDING. ASK FOR YOUR EMPLOYER'S SAFETY PRACTICES WHICH SHOULD BE
BASED ON MANUFACTURERS' HAZARD DATA.
ELECTRIC SHOCK - - Can kill
Install and earth the welding unit in accordance with applicable standards.
S
Do not touch live electrical parts or electrodes with bare skin, wet gloves or wet clothing.
S
Insulate yourself from earth and the workpiece.
S
Ensure your working stance is safe.
S
FUMES AND GASES - - Can be dangerous to health
Keep your head out of the fumes.
S
Use ventilation, extraction at the arc, or both, to keep fumes and gases from your breathing zone and
S
the general area.
ARC RAYS - - Can injure eyes and burn skin.
Protect your eyes and body. Use the correct welding screen and filter lens and wear protective
S
clothing.
Protect bystanders with suitable screens or curtains.
S
FIRE HAZARD
Sparks (spatter) can cause fire. Make sure therefore that there are no inflammable materials nearby.
S
NOISE - - Excessive noise can damage hearing
Protect your ears. Use ear defenders or other hearing protection.
S
Warn bystanders of the risk.
S
MALFUNCTION - - Call for expert assistance in the event of malfunction.
READ AND UNDERSTAND THE INSTRUCTION MANUAL BEFORE INSTALLING OR OPERATING.
ba13d12e
WARNING
PROTECT YOURSELF AND OTHERS!
- - 30 - -