Gabarron GTS 10 Instrucciones De Instalacion Y Uso página 10

3.- OPERATING THE WATER HEATER
Connect the water heater to the electrical socket. The heating indicator will be lit as long as the heating
element is energized. The light will go out when the desired temperature is reached.
The setting of the water temperature can be modified by turning the Temperature Controlling Knob up to
75ºC max.
The thermostat will maintain the water temperature as long as the water heater is connected to the
electricity supply.
If there is any risk of frost conditions may be opportune to empty the water heater. It could be done by
means of the Preassure Relief Valve.
0.8MPa
Should any continuous water steam or boiling water is delivered at draining hole or at any hot water
system tap disconnect immediately the water heater from the electrical socket and get in contact with
after sales service.
4.- MAINTENANCE
IMPORTANT: Check every month that the Pressure Relief Valve is not blocked. Operate the spanner to
drainage position. If the Pressure Relief valve is obstructed it must be replaced.
Every two years it is necessary to arrange heating element de-scaling works at the same time it is
necessary to check the magnesium anode if required. The warranty will not cover any damage caused
by the inobservance of this point and if the anode is completely gone due to lack of maintenance.
Clean and dust with a dry, soft cloth only when the unit is disconnected and cold.
Do not use solvents or abrasive products for cleaning.
Do not immerse the electric water heater in water.
Do not allow the interior to get wet as this could create a hazard.
Plastic Cover
Heating Indicator
Hot Water Outlet
Fixed Screw Nail
Pressure relief
Temperature
Controlling
Knob
Cold Water Inlet
Water-drainage Position
0.8MPa
Water- drainage Spanner