General 840 Guia Del Usuario página 11

9. Loosen SLIDE LOCK SCREW (E)
and move the SLIDE (F) along the
SCALE ROD (G) until the distance
the SLIDE (F) is away from the
edge is half the thickness of board
"A", Use the graduations marked
on the SCALE ROD (G) for
measuring (See Figure 18),
Once aligned, tighten SLIDE
LOCK SCREW (E).
10. Lift TURRET (H) and turn until the correct size hole is aligned
with the INDEX MARK (D), The TURRET (H) will snap into
place when properly located.
11. ENSURE THE DRILL IS TURNED OFF. Place a depth stop
collar on the drill bit at the proper depth to drill the first hole,
NOTE: Position the collar to allow
for TURRET (H) height as well as
desired depth of hole.
12. Ensure SLIDE (F) is locked at
proper position and drill dowel
hole in board "B", The hole in the
TURRET (H) will help you keep
the drill straight (See Figure 19).
13. With clamp in place, loosen the
jig CLAMP SCREW (B) and move
the jig so the next marked
location on the board aligns with
the INDEX MARK (D) on the jig,
14. Gently tighten the CLAMP SCREW (B) and repeat steps 8–13
until all dowel holes are drilled,
15. Apply glue to the dowel pins and insert them in the holes in
board "A", AIign the holes in board "B" with dowel pins
connect boards "A" and "B" to make the joint.
Figure 18
Figure 19
11