Best Fluttua HF Touch White 80 Instrucciones De Uso página 13

the alarm, press one of the keys for 2" during alarm display.
After 120 hours of motor operation, the charcoal filter alarm is
activated (all the LEDs blink). The alarm is activated when the
motor is off and remains displayed for 30". To deactivate the
alarm, press one of the keys for 2" during alarm display.
CONTROLS
P1 P2 P3
P1: It turns on an off the light.
P2: It starts the engine setting it to the first speed (the icon
is highlighted). Other speed icons remain inactive.
P3: It starts the engine setting it to the second speed (the
icon is highlighted). Other speed icons remain inactive.
P4: It starts the engine setting it to the third speed (the icon
is highlighted). Other speed icons remain inactive.
P5: It starts the engine setting it to the fourth speed (the
icon is blinking). Other speed icons remain inactive. The
maximum speed is set to be maintained for maximum 5
minutes, after this time the speed will be automatically
adjusted to the third speed.
P6: It starts the timer (the icon is highlighted). By running
the timer (5 minutes), the engine stops automatically after
5 minutes.
P7: FILTER ALARM. After 30 hours of operation the icon is
highlighted to indicate that the filter should be cleaned.
After 120 hours of operation the icon is highlighted to
indicate that the grease filter should be cleaned and the
charcoal filters - replaced.
To RESET the alarm, press the icon while it is highlighted
(or while it is
blinking).
MAINTENANCE
! Before cleaning or maintenance cut the power.
! Failure to comply with the rules of cleaning of the
appliance and replacement of the filters entails the risk
of fire. Follow the suggested instructions.
Cleaning the hood
WHEN TO CLEAN IT: frequently both externally and
internally.
EXTERNAL CLEANING: use a cloth moistened in
lukewarm water and neutral detergent (for painted hoods);
use specific products for steel, copper or brass hoods.
INTERNAL CLEANING: use a cloth moistened in neutral
liquid detergent.
WHAT NOT TO DO: do not use alcohol or abrasive or
corrosive products (e.g. metal sponges, brushes
that are excessively hard, very aggressive detergents,
etc.)
Cleaning the grease filters
HOW TO REMOVE THE FILTERS: push handle down and
pull the filters towards the outside of the hood.
WHEN TO CLEAN IT: clean it at least every month or when
the "filter alarm" system indicates the need.
P4 P5 P6 P7
HOW TO CLEAN THE FILTERS: hand wash or in the
dishwasher using a neutral detergent. If washing in the
dishwasher, possible discoloration of the filters does not
in any way compromise their functioning.
Replacing the charcoal filter (P)
(for filtering version only)
WHEN TO REPLACE IT: at least every 4 months and in any
case on the basis of saturation of the same.
HOW TO REMOVE IT: remove the charcoal filter by first
removing the two stop filter (M).
Replace it by repositioning the filter-holders (M).
M
If the light spot is damaged, it must be replaced only by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard
MALFUNCTIONS
If something appears not to be working properly, do the
following simple checks before calling Technical Service:
• If the hood is not working:
Check that:
- The power has not been disconnected.
- A speed has been selected.
• If the hood performs inefficiently:
Check that:
- The motor speed selected is sufficient for the amount of
smoke and vapours released.
- The kitchen is sufficiently ventilated to allow air intake.
- The charcoal filter is not saturated (hood in filtering
version).
• If the hood has turned off during normal functioning:
Check that:
- The power has not been disconnected.
- the omnipolar disconnection device has not tripped.
= Components NOT provided with the
product
P