Sensorspezifische Parameter - Balluff BIP LD2-T017-01-EP Serie Manual De Instrucciones

BIP LD2-T017-01-EP _ _ / EP _ _ -S4
Induktives Positionsmesssystem
6
IO-Link-Schnittstelle (Fortsetzung)
6.6

Sensorspezifische Parameter

Index Subindex Parameter
hex (dez) hex (dez)
0x0052 0x00 (0) Device Temperature
(82)
0x01 (1) Device Temperature
Actual
0x02 (2) Device Temperature Min
0x03 (3) Device Temperature Max int8 (1 Byte)
0x04 (4) Device Temperature Min
Lifetime
0x05 (5) Device Temperature Max
Lifetime
0x0053 0x00 (0) Device Temperature
(83) Thresholds
0x01 (1) Device Temperature
Thresholds Min.
0x02 (2) Device Temperature
Thresholds Max.
0x0057 0x00 (0) Operating Hours
(87)
0x01 (1) Operating Hours total
0x02 (2) Operating Hours since
maintenance
0x03 (3) Operating Hours since
startup
0x0058 0x00 (0) Boot Cycle Counter
(88)
0x01 (1) Boot Cycles total
0x02 (2) Boot Cycles since
maintainance
0x00C1 0x00 (0) PDV Offset
(193)
0x00C2 0x00 (0) PDV Preset
(194)
0x00C3 0x00 (0) PDV Charakteristik
(195)
0x00C4 0x00 (0) PDV Enable Detection
(196) Range
0x4080 0x00 (0) MDC Descriptor
(16512)
0x01 (1) MDC Low Limit
0x02 (2) MDC High Limit
0x03 (3) MDC Unit Code
0x04 (4) MDC Scale
Tab. 6-8: Sensorspezifische Parameter
www.balluff.com
Datenformat Zugriff
(Länge)
int8 (5 Bytes) Read only
int8 (1 Byte) Read only
int8 (1 Byte) Read only
Read only
int8 (1 Byte) Read only
int8 (1 Byte) Read only
int8 (2 Byte) Read/Write
int8 (1 Byte) Read/Write
int8 (1 Byte) Read/Write
uint32 Read only
(12 Byte)
uint32 (4 Byte) Read only
uint32 (4 Byte) Read only
uint32 (4 Byte) Read only
uint32 (8 Byte) Read only
uint32 (4 Byte) Read only
uint32 (4 Byte) Read only
int16 Read/Write
int16 Read/Write
uint8 Read/Write
uint8 Read only
(7 Bytes) Read only
int16 (2 Bytes) Read only
int16 (2 Bytes) Read only
uint16 (2 Bytes) Read only
int8 (1 Byte) Read only
Werte bereich/ Bemerkungen
(Vorgabewert)
Alle Werte
–128...+127
–128...+127
–128...+127
–128...+127
–128...+127
–128...+127
–128
127
–15000...
+32000
–32000... Neuer Ausganswert
+32000 beim Preset Teach-In
0x00 – normal
0xFF – invertiert
(0x00) Funktion nicht
implementiert
(0)
(17000)
1010 Unit Code für μm
–6
deutsch 15