Reaming Pipe With Hand Reamer; Threading Pipe With Hand Threader - RIDGID 300 Only Manual De Instrucciones

Accionamiento de potencia
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

300 Power Drive

Reaming Pipe with Hand Reamer

To prevent serious injury, do not use self-
WARNING
feeding spiral reamers with the 300 Power Drive.
1. Flip the directional switch to FOR (Forward).
2. Place the reamer in the end of the pipe (see the
"Accessories" section for reamers recommended for
use with this Power Drive).
3. Assume the correct operating posture.
4. Rest handle on the left support bar (Figure 6) and hold
the reamer handgrip with the right hand. To avoid
pinch point injuries, keep your fingers from coming
between the reamer and the support bar.
5. Firmly grasp the end of the reamer handle with the left
hand, then depress and hold the foot switch down.
6. Push the reamer firmly into the pipe with your right
hand until ream is complete. Keep your hand and arm
away from any rotating parts and use a firm grip on
the handgrip.
7. Release the foot switch and remove your foot from the
housing while holding the reamer with both hands.
Straight Hand Reamer
Support Bar
Handle
Figure 6 – Reaming Pipe with Hand Reamer
8. Remove the reamer from the workpiece once the
Power Drive has stopped rotating.
Hand Grip
Ridge Tool Company

Threading Pipe with Hand Threader

1. Place the die head of the hand threader on the end of
the pipe (see "Accessories" section for hand thread-
ers recommended for use with this Power Drive).
2. Position the ratchet knob on the hand threader so that
the arrow on the knob points up.
3. Rest the hand threader ratchet handle on the left
support bar (as viewed when facing the front of the
Power Drive – Figure 7).
To avoid pinch point injuries, keep your fin-
WARNING
gers from coming between the hand threader and the
support bar.
Hand Threader
Ratchet
Knob
Support
Bar
Figure 7 – Pushing Hand Threader onto Pipe to Engage
Dies
4. Apply RIDGID Thread Cutting Oil to the end of the pipe.
5. Assume the correct operating posture. Check to ensure
directional switch is in the FOR (Forward) position.
6. Hold the die head against the workpiece with the
right hand.
WARNING
To avoid injury from rotating parts or sharp
surfaces, keep hands and fingers away from anything
other than the outer body of the die head.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

300 complete4185575075418607543515682 ... Mostrar todo

Tabla de contenido