Replacing The Battery; Understanding Naída Ci Leds - Advanced Bionics Naida Cl Q70 Manual De Instrucciones

Replacing the Battery

1
Hold the Naída CI in one hand. Rotate
the RF cable upward to avoid bumping it
upon battery placement.
3
Slide the battery onto the processor
until it clicks into place.
Do not force the battery cartridge onto the processor. The battery cartridges are
NOTE:
designed to be inserted in only one direction; applying force may damage the equipment.
24
Naída CI Sound Processor User Guide
2
Align the battery cartridge connector
with the processor housing side of
the connector.
Understanding Naída CI LEDs
The Naída CI LEDs are a programmable feature providing visual information about the Naída
CI status, battery life, program position, and error conditions.
Naída CI Sound Processor LED Indications
Color Behavior Programmable
Orange Blinks at start-up No. Battery indicator is
only available with use
of the rechargeable
PowerCels and AAA
PowerPak. Battery life
indicators are not
available with use of
Zn-Air batteries.
Solid Yes
Blinks twice every Yes
three seconds
Fades out No
Yes
Red Blinks once
per second
Blinks rapidly (more No
than once per
second)
No
Solid
Blinks 5 times No-if using AB myPilot
this pattern is the default
Green Flickers in response Yes
to loud inputs
Blinks at start-up, No
after battery
status, and upon
program change
Solid Green No
Blinks 4 times No-if using AB myPilot
this pattern is the default
Use of some Naída CI accessories may obscure the processor LED.
NOTE:
Indication
4 quick blinks indicate that the
•
battery is fully charged
2 - 3 quick blinks indicate that the
•
battery is sufficiently charged to
power the Naída CI
1quick blink indicates that the
•
battery is nearly depleted
No blinking indicates depleted
•
battery. Replace with charged or
new battery
The battery is almost depleted
The battery is almost depleted
and cannot support stimulation
(Sleep Mode)
The Naída CI is entering Sleep Mode
Loss of lock with the implant
Intellilink™ enabled and the Naída
CI is connected to the wrong implant
Sound processor error condition. Fully
remove and re-insert the battery to
reset processor
Response to AB myPilot's request to
'Find Paired Devices'. The Right paired
device will identify, itself with this LED
pattern.
The sound processor and microphone
are responding to sound
1 blink indicates program one
•
2 blinks indicate program two
•
3 blinks indicate program three
•
4 blinks indicate program four
•
5 blinks indicate program five
•
A processor that is not yet programmed
Response to AB myPilot' s request to 'Find
Paired Devices'. The Left paired device will
identify, itself with this LED pattern.
25
Naída CI Sound Processor User Guide